Magnetic angle sensor RM36 5В and 24V, non-contact
- Production:
- Renishaw (United Kingdom)
The sensor consists of a magnetic actuator and, separately, the sensor housing. The rotation of the magnetic actuator detects a microcircuit placed inside the casing and converts changes in the magnetic field gradient into an output signal of a certain format.
The received signals are interpolated and at the output of the sensor itself have a bit capacity of up to 13 bits (8192 signals/rev), with an operating speed of rotation of the actuator up to 30,000 rpm. The output signals are compatible with all industry standards and have an incremental or analog formats.
- how sensor is made
Specifications:
- Diameter, mm: 36,5
- Sensor weight with 1m cable (without connector), g: 85
- Weight of magnetic actuator, g: 12
- Length with magnetic actuator, mm: 33
- Housing design: non-contact
- Resolution, bit: up to 13 (8192 signals/rev)
- Output formats: incremental and analog (compatible with industry standards)
- Maximum rotation speed, rpm: up to 30,000
- Maximum error: ± 0.5 °
- Supply voltage, V: 5 and 24
- Degree of protection: IP64, IP68
- Cable output: radial
- Diameter of the attached drive shaft, mm: 4, 5, 6, 8, 10
- Connector types: without connector, 9-pin or 15-pin "D" connector (parallel format only)
- Operating temperature, ° C: -40 to +125 (depends on the type of output)
- Sensor body material: aluminum.
- Actuator material: stainless steel